Rebar Coupler Joint Location

The location of steel sleeve connection joints

1. The joint is located in the position where the tensile steel stress is small. When the joint is set to a high stress position, the percentage of Class III joints in the same connection section cannot be big than 25%. The percentage of Class II seams should not be big than 50%, and the percentage of Class I seams should not be limited.


2. The node avoids the seismic fortification requirements of the frame beam end and the column end stirrup densification area. When it is unavoidable, the percentage of Class II joints or Class I joints should not over 50%.

3. For parts with low tensile strength or longitudinal compression, the percentage of joints is not limited.


Changsha DLADTO Rebar Splice Co., Ltd is a professional rebar coupler producer, we have been in this field for a long time with customers for all over the world. If you have any inquiry, welcome to contact us.

评论

发表评论

此博客中的热门博文

How To Adjust Positive And Negative Thread On Thread Cutting Machine ?

图片
1   Remove the  eccentric bushing  and eccentric shaft from the thread holder, loosen the screws first, and then use a special wrench for the eccentric bushing to rotate the eccentric bushing 180 degrees . Then, place the loosened screws into the screw hole after the rotation of 180 degrees and tighten them (the rolling head and rib stripping head are equipped with 3 eccentric bushing, each with a 180 degree rotation, and tighten them by changing the screw hole). 2 Install the threading roller and place it counterclockwise in 1-2-3  (POSITIVE THREAD)    Install the threading roller and place it anticlockwise in 3-2-1  (NEGATIVE THREAD) 3 Upper the rib stripping machine head, tighten the screws, adjust the test bar, and start working
阅读全文

Several Advantages of Using Straight Threaded Steel Bars

图片
1. The steel connecting sleeve is able to reduce the use of materials and easy to operate which not limited by the types of steel components. 2. The  straight threaded sleeve  can be connected conveniently, quickly and simply, they not need electricity in construction. 3. They can connect horizontal, vertical and oblique HRB335 and HRB400 steel bars of the same diameter or different diameter. The specifications and models of straight-threaded steel bar connection sleeves that our factory can produce are φ14-φ40 ordinary steel bar connection sleeves, adjustable steel bar connection sleeves, different diameter steel bar connection sleeves, and special steel bar connection sleeves. And provide wire rolling machine products of steel straight thread processing equipment.
阅读全文

Problems Encountered During Rebar Coupler Processing

图片
 Rebar coupler is also known as mechanical splices in the construction industry. The common specifications of the  rebar coupler  are M12, M14, M16, M18, M20, M22, M25, M28, M32, M36, and M40. The most commonly used specifications are M16, M18, M20, M22, M25, M28, and M32. These are the most used on the site, but also the most commonly used. Today, we will introduce to you how to solve the wrong diameter or length problems encountered in the processing of steel sleeves.  Causes:  1. The specifications of raw materials are not accurate, and the feeding speed is too slow. 2. Raw materials are bent and not straightened before processing. 3. The mechanical equipment malfunctioned, resulting in the diameter of the rebar coupler becoming smaller. 4. Operators do not process according to engineering drawings.   Solutions: 1. Adjust raw material specifications and models, and pre-feed appropriate amount. 2. Straighten the round bend steel before cutting the raw material. 3. Check the mechanica
阅读全文